LIC-100 ISOLATION COUPLER

LIC-100 ISOLATION COUPLER

DESCRIPTION
The LIC-100 isolation coupler is used to connect a logging recorder to telephone circuits, two-way radio lines, etc. It provides a balanced line-input, transformer isolation, capacitive coupling, RF bypass, and balanced line-output.

The high impedance input circuit permits connection to balanced and unbalanced audio sources, with minimal loading. No internal or external power is required, 3"L x 2"W x 1"H.

INSTALLATION
The input cable (normally supplied with a modular RJ-11 telephone style plug pre-installed on the end) should be connected to the source of audio to be monitored. If the modular plug is not used, connect the red wire in the cable to one side of the circuit and the green wire to the other side of the circuit. Polarity is not important.

Connect the output cable (normally supplied with a 3.5mm mini-plug labeled AUX) to the audio input of your recording equipment. With Omnicron recorders this cable should plug into the "AUX" (auxiliary/line input) jack on the recorder.

If the coupler was purchased as part of a pre-wired recording system, the input and/or output cable terminations may have been changed to match your specific application.

IMPORTANT NOTES
Use of the LIC-100 coupler on telephone circuits which are not private may be regulated by local tariffs. If local tariffs apply, contact your telephone company for application assistance.

Do not use the LIC-100 on a party or pay phone line, since it will record the conversations of all parties. This would be unlawful.

If you are using the coupler with a voltage controlled telephone circuit, the LIC-390 coupler should be used in place of the LIC-100. The LIC-390 coupler has a voltage sensing audio mute circuit which prevents your recorder's voice activation circuit from being triggered by noise on the phone line between calls.

Federal law 90-351 title 18, section 2511, sub section 2D, requires that at least one participant in a recorded conversation be informed of the recording. Check your state and local regulations for further guidelines.

The LIC-100 is warranted to be free from defects in materials or workmanship for 90 days from the date of purchase. Damage to products resulting from physical abuse or electrical misuse voids this warranty. Out of warranty units will be repaired for a nominal handling charge plus the cost of parts and transportation. If the unit requires service, disconnect and return to the factory or place of purchase for repair.

These adapter are only for use with the Telecorder and the Toatal Record product line
any use of the adapters with any other prodcuts is at the customers own risk
AB Selcom and Omnicron Electronics will not be held accountable for any lack of performance
or failure of the customer equiptment do to using this adapter